Extraflame Comfort Mini, User Manual

Page: 26 / 48

26
PRODUCT FUNCTIONALITY
Chapter7
PRODUCT FUNCTIONALITY
BASIC INSTRUCTIONS
The stove you have purchased uses pellets as fuel. This type of material is produced from natural waste from
woodworking. By means of a special process, which does not require the use of any binders or additives,
the shavings are compressed in industrial machines under high pressure and become solid wooden pellets.
IT IS STRICTLY FORBIDDEN to burn any other material besides pellets in our stove. Failure to respect these
instructions will void all warranties and may jeopardise the safety of the appliance.
The fi rst two or three times the stove is lit, the following recommendations should be observed:
No children should be present, as the vapours emitted can be harmful for health. Adults, too, should
™
not stay in the vicinity for very long.
Do not touch the surfaces, as they could still be unstable.
™
Air the room thoroughly several times.
™
The hardening of the surfaces is completed after several heating processes.
™
This stove
™
must not be used as a waste incinerator.
IGNITION
Before proceeding, check to make sure that: 1.
the tank is loaded with pellets
™
the combustion chamber is clean
™
the brazier is clean and free
™
the fi re door and the ash drawer are sealed
™
the power cable is connected correctly
™
the two-way switch on the back of the stove is in position 1
™
Press button 1 for three seconds; display D1 will show the message “ 2. START ”. During this stage, the stove
carries out an automatic check on the effi ciency of each single electrical component. When this cycle is
completed, display D1 shows the message “ IGNITION 15 ” (the number of minutes for which the stove
attempts the lighting stage, decreasing by 1 every minute that passes).
The fi rst time the stove is used, even if the tank is loaded with pellets, it is possible that the pellets
are not distributed to the combustion chamber for the fi rst 15 minutes because the worm screw for
loading the pellets is empty. If the stove has not developed a fl ame after the fi fteen minutes have
elapsed, the display shows the message “
NO FLAME ”.
If points 1 and 2 are carried out correctly, the stove will enter the “ 3. START UP 07 ” stage.
After the lighting phase, the stove will enter the working phase and the display will show the room 4.
temperature, heating power and stove status.
WARNING!!!
1. NEVER USE FLAMMABLE LIQUIDS FOR LIGHTING
2. WHEN FILLING, DO NOT BRING THE SACK OF PELLETS INTO CONTACT WITH THE HOT STOVE
In case of continued ignition failures, contact an authorised technician.