Extraflame Comfort Mini, User Manual

Page: 19 / 48

19
COMFORT MINI/P80/MINI CRYSTAL INSTALLATION
Chapter5
The tank support can only be fi tted on the
right-hand side of the insert.
Adjust the height and angle of the tank according to the
fi replace to be built.
The insert must stand at least 1 cm above the
marble fi re top of the facing.
EXTRACTING THE INSERT
Extraction of the insert allows to feed the pellets into the tank
and to perform routine maintenance (cleaning the ash chute
every year) or extraordinary maintenance (replacement of
mechanical parts if the product should break).
These operations must be carried out by an
authorised technician, with the stove switched
off and the plug disconnected.
To extract the insert, proceed as follows:
Open the fi re door and use the socket wrench provided to 1.
turn the screw in the lower left-hand corner anticlockwise.
Using the pokers provided, pull the insert towards you 2.
until it blocks automatically.
FITTING THE FRAMES
Front frame
™
Side frames
™
Attach the front frame to the two side frames.
Fix the frames to the insert using self-tapping screws.
N.B. Any wooden beams situated above the insert must be
protected using fi reproofi ng material.
Frame assembly is important, as it allows correct air
circulation in the insert and consequently the most effi
cient
stove operation.
The 2 side frames are fi tted to the upper
frame using 2 screws per side.
The remaining holes on the side frames
are used for attaching the entire frame
assembly to the sides of the insert using
self-tapping screws.
fi gure 5.7
fi gure 5.8
fi gure 5.9