Extraflame Comfort Mini, User Manual

Page: 34 / 48

34
ROOM THERMOSTAT
Chapter9
ROOM THERMOSTAT
MECHANICAL THERMOSTAT (OPTIONAL)
A thermostat can be placed in a room adjacent to the one in which the stove is installed. Just connect
a mechanical thermostat (like those used for boilers) following the procedure described below. (We
recommend positioning the optional thermostat at a height of 1.50 m above fl oor level.).
Installation must be carried out by an authorised technician.
INSTALLING A MECHANICAL THERMOSTAT (OPTIONAL)
Switch off the appliance using the master switch on the back of the stove. 1.
Disconnect the plug from the socket. 2.
Referring to the electrical wiring diagram, connect the two thermostat wires to the respective terminals 3.
on the back side of the stove, one red and one black.
Installation must be carried out by an authorised technician.
MECHANICAL THERMOSTAT OPERATION
Light the stove using button 1. 1.
Set the desired heating power using buttons 4 and 5. 2.
Use the 3. menu 1 button to go to the menu “ ROOM TEMP SET ” and set on “ MIN ” using button 4.
Set the desired room temperature on the external thermostat (e.g. 21 °C). 4.
At this point, the external thermostat will control stove operation as follows:
Thermostat with closed contact
™ D
the stove switches on and operates at the power set, and the
display shows “ T ON ”.
Thermostat with open contact
™
D
the stove goes to the minimum power even if the display shows the
previously set value; the display will then show “ MIN ”.
MECHANICAL THERMOSTAT OPERATION IN STANDBY MODE (TO BE USED ALSO
FOR REMOTE ACTUATOR)
The Standby function is used to further reduce pellet consumption by switching off the stove when the
desired temperature has been reached.
As the temperature drops, the stove will automatically switch on again.
Set the desired temperature using buttons 4 and 5. 1.
Use the 2. menu 1 button to go to the menu “ ROOM TEMP SET ” and set on “ MIN ” using button 4.
Press button 1 for three seconds; the display will show “ 3. STBY ”.
At this point the thermostat will control the stove as described below:
Thermostat with closed contact:
™
D
the stove switches on and operates at the power set. The display
shows “ T ON ”.
Thermostat with open contact:
™ D
the stove switches off or stays off , and the display shows “ STBY ”.