42
3111001 Xzense UK 20190731
Purchase of accessories
Setting up multiple repeaters
In the example to the right is shown a control panel (2) at the
stove, a power unit (3) on the chimney and 3 pcs. repeaters
(1). The signal between the power unit and the control panel
will go through all the repeaters here.
1. Location of first repeater (1). Use the control panel (2) to
find the location that the signal can reach without a repeater.
2. Turn on the display and go to the Signal menu. Select
Signal Test.
The control panel now performs a signal test to ensure that
there is an optimal signal between the control panel and the
power unit.
3. Set up the repeater at the location where signal can still
be obtained.
4. Activate the repeater by holding it for 2 seconds.
5. Turn on the display and go to the Signal menu and select
Devices.
6. Select the repeater in the overview to pair the devices.
Enter the four digit code/ID of the specific repeater, finish
with OK.
7. If the repeater does not appear by itself, Add device in the
right corner can be used and the code/ID can be entered.
Finish with OK.
If no device can be found, it is because there is no signal
and the repeater is too far away.
If more repeaters are required, follow the procedure in the above points.
The chimney fan can now be operated from the control panel.
3.4. Technical data
Dimension (h x b x d)
75 mm x 85 mm x 25 mm
Input, supply
5 VDC - USB
Ingress protection
IP20
Material
Box: Black ABS - Lid: Black PC
Ambient temperature
-30 °C to 60 °C
Summary of Contents for Xzense
Page 1: ...UK Always read and save the instructions 3111001 Xzense UK 20190731 ...
Page 50: ......
Page 51: ......
