Exodraft Xzense, Instruction Manual

Page: 17 / 52

3111001 Xzense UK 20190731
17
Product information
2.5. Test of communication/signal
Step Action Display
1
Turn on the control panel by clicking the button on the
top.
Plug in the USB-cable if needed.
2
The screen now lights up on the home screen.
If the display shows the text ”No connection to Power
Unit”, there is no strong signal connection. Try moving
the control panel for better contact.
See the section on Setup - Mounting,
for more information.
Optænding Ventilation Vejrstation
OK
Error 1
No connection to
Power Unit
3
When mounting and signal errors
If you want to mount the wall bracket in order to have a
station for the control panel, it must be ensured that the
unit can receive signal from this location.
Always check if there is a signal before mounting, by
pressing the signal icon under the Signal Test.
SIGNAL TEST
Waiting for client..
------ results ------
2.6. Signal test
Step Action Display
1
To test the signal strength, enter the Signal Test menu,
which is available using the following menu:
1. General
2. Network
3. Communication
4. Signal test
KOMMUNIKATION
Signalastyrke Tilføj enhed
Nulstil netværk Devices Signal test Reset network
SIGNAL
2
Press the signal icon and the test starts.
The display sends 100 data packets out, and responds
them back to the unit. The more packets sent back,
the better the signal is right where the control panel is
located or located compared to the repeater.
If there are many data packets left, the signal is bad and
you should find a better place for its control panel.
SIGNAL TEST
Receiving from fra F1EE
Rx: 89/100