Exodraft Xzense, Instruction Manual

Page: 41 / 52

3111001 Xzense UK 20190731
41
Purchase of accessories
3. Accessories - Repeater
A repeater must be ordered/purchased separately and are not included
in an Xzense set of Control panel and Power Unit!
3.1. Setup - Mounting
The repeater makes it possible to obtain a signal if there is too much distance between the control panel and the
power unit or if the signal has to pass through, for example, several storeys.
The signal can at most go through 3 pcs. repeaters between an Xzense power unit and a control panel. The
repeater is placed between the Xzense control panel and the power unit, which is typically mounted on the
chimney.In some situations, it would be appropriate to set up the repeater outdoors, eg under the overhang or
on another building. The signal may have difficulties to get through certain materials, for example, steel and
aluminum constructions.
3.2. Range
Range between units should not exceed 18 meters.
3.3. Setting up one repeater
In the example to the right is shown a control panel (2)
at the stove, a power unit (3) on the chimney and a repeater (1).
Add the repeater to the control panel:
1. Turn on the display and go to the Signal menu and
select Devices.
2. Select the repeater in the overview to pair the devices.
Enter the four digit code/ID of the specific repeater, finish
with OK.
3. If the repeater does not appear by itself, Add device in
the right corner can be used and the code/ID can be ente-
red. Finish with OK.
4. Alternatively, the button on the repeater can be acti-
vated by holding it for 2 seconds. Then the pairing via the
control panel can be done without code, if only the signal
amplifier is selected on the overview within 2 minutes.
When the devices are paired properly, a dialog box will
appear.
5. Set up the repeater (1) somewhere between the power
unit on the chimney and the control panel. The chimney
fan can now be operated from the control panel.