EXFO LTB-8, User Manual

Page: 374 / 402

Communicating Through TCP/IP Over Telnet
366
LTB-8
Executing SCPI Commands Over Telnet
To execute SCPI commands over Telnet from a remote
Windows client:
1.
Establish a connection to the Telnet service as follows:
1a. From your computer, start Windows.
1b. On the taskbar, click Start (Start button ( ) under Windows 8.1
and Windows 10) and select
Run
.
Note:
Depending on the operating system, Run can sometimes be found under
Windows System
.
1c. In the Open box, type telnet , and then click OK .
Note: If you receive an error message, it probably means that the Telnet client is
not already activated on your computer. In this case, in the
Open box, type
pkgmgr /iu:TelnetClient , and then click OK to enable the client. Once it is
done, perform step 3 again.