11
TOOL
13-15mm Wrench
ASSEMBLY
STEP 1
1A. Setting Up the Frames:
Pull apart the
Front Frame (2)
and the
Rear Frame (1)
. Rest the
Rear Frame Support Tube (67)
into the hooked plate on the
Rear Frame (1)
. Align the pin holes
where the
Front Frame (2)
and
Rear Frame (1)
intersect and insert the
Safety Pin (22)
into the
aligned holes.
See Figure A
. The aligned holes can be found by tracing the
Safety Pin (22)
in the
illustration.
1B. Installing the Front Stabilizer:
Attach the
Front Stabilizer (31)
to the
Front Frame (2)
with
two
Hexagon Cap Nuts (29),
two
Spring Washers (102)
, and two C
urve Washers (30)
.Then
tighten the
Hexagon Cap Nuts (29)
using the
13-15mm Wrench
provided.
1C. Installing The Rear Stabilizer:
Attach the
Rear Stabilizer (3)
to the
Rear Frame (1)
with two
Hexagon Cap Nuts (29)
, two
Spring Washers (102)
, and two
Curve Washers (30)
. Then tighten
the
Hexagon Cap Nuts (29)
using the
13-15mm Wrench
provided.
HARDWARE PACK
(29) Hexagon Cap Nut
4PCS
(102) Spring Washer
4PCS
(30) Curve Washer
4PCS
(22) Safety Pin
1PC
Figure A
Summary of Contents for EXERWORK 1000
