Exerpeutic 1112.8-101016, Owner'S Manual

Page: 18 / 33

6. Front Post and Front Post Cover and Foot Pedals Installation
Use the 6mm Allen Wrench with Phillips Screwdriver to remove four Washers (40), four
Bolts (49), one bolt (39), and one Big Curve Washer (36) from the tube of the Front Main
Frame (73). Slide the Front Post Cover (54) up to the Front Post (48). Connect the
Extension Sensor Wire (51) and Extension Hand Pulse Sensor Wire II (55) from the Front
Main Frame (73) to the Extension Sensor Wire I (50) and Extension Hand Pulse Sensor
Wire III (44) from the Front Post (48).
Insert the Front Post (48) onto the tube of the Front Main Frame (73) and secure it with
four Washers (40), four Bolts (49), one bolt (39), and one Big Curve Washer (36) that were
removed. Lightly tighten four Bolts (49) on the side of the Front Post (48) and one Bolt
(39) on the front of the Front Post (48) by hand. After all five bolts are tightened by
hand, tighten the front Bolt (39) with 6mm Allen Wrench with Phillips Screwdriver until
secure. Then tighten the other four Bolts (49)
on the side of the Front Post (48) with 6mm
Allen Wrench with Phillips Screwdriver. Slide the Front Post Cover (54) down to the Front
Main Frame (73).
ASSEMBLY
16
6mm Allen Wrench with
Phillips Screwdriver
1 PC
Tool: