Issue
1.10.D
GX server – Version 1.10 – User Manual
EVS Broadcast Equipment – September 2012
22
The table below describes the status information fields:
Option
Description
GX version
Software version number of the GX server.
Disk capacity
Remaining capacity on both Raw Materials and GX Clips
drives. It is expressed as a percentage of the total drive
capacity.
IP address
IP address of the network interface card (NIC) that allows the
GX server to communicate over the network.
Protocol
Protocol the GX server is currently set to work with.
Output format
Currently selected video standard.
When the GX server is started, only GX clips created in the
selected video standard will be visible to the protocol clients.
The value corresponds to the one selected in the
Video
Standard
field in the Settings area.
Genlock status
Quality of the genlock signal.
The messages on the genlock quality can be the following:
•
Valid:
Good genlock
•
Bad (no signal):
No genlock signal detected
•
Bad (mismatch):
Genlock signal detected, but
not in the correct format
If the genlock quality is bad, the genlock information is
displayed in red. Otherwise, this is in green.
Running process
Activity status on the GX server:
•
The status is 'Importing' if raw materials are being imported
onto the Raw Materials drive.
•
The status is 'Setting online' if GX clips are being uploaded
onto the GX Clips drive.
•
The status is 'Idle' if there is no activity.
Status indication
GX server status:
•
The status is 'Not started' when the server is not running.
•
The status is 'Active' when the GX server has been started
and is awaiting commands.
Clip name
Name of the GX clip that has been loaded by the protocol
client.
GX message
Error, warning or general message reported by the GX server
and displayed on the OSD of the SDI Fill output.