DEPOLOX
®
5 E flow cell
Installation
4.
49
4.4.10
Removing the felt ring
To keep the diaphragm moist and prevent crystallization in the
electrolyte solution there is a moist felt washer in the gap between
electrolyte tank and electrode when the unit is in storage.
Attention!
Before initial startup, the felt washer for moistening the mem-
branes must be removed.
Proceed as follows:
1
Extract the knurled nut (A) from the cover of the electrolyte
tank.
2
Remove the entire electrode unit from the cell body from
below.
3
Remove the felt washer (B) between electrolyte tank and elec-
trode.
4
Refit the entire electrode unit in the cell body. With the locating
pin, observe the exact position in the cell body.
5
Push the entire electrode unit upwards.
6
Refit the knurled nut on the electrolyte tank.
Figure 7
Cross-section of cell body, non-pressurized version
(example knurled nut)
A
Knurled nut
B
Felt washer
A
B
Summary of Contents for WALLACE & TIERNAN DEPOLOX 5 E
