EVO42
5
www.evolutionsteel.com
SAFETY LABELS & SYMBOLS
WARNING:
Do not operate machine if
warning and/or instruction labels are missing
or damaged. Contact Evolution Power Tools for
replacement labels.
Note:
All or some of the following symbols may
appear in the manual or on the product.
SYMBOL
MEANING
Eye protection should be worn
at all times when using this tool.
Hard Hat -
Head protection should be worn
at all times whilst using this tool,
to protect from overhead hazards
Ear protection / Ear defenders
should be worn at all times
whilst using this tool, this tool
exceed 85dB(A)
Electrical enclosure -
risk of electric shock.
Read and understand the
instruction manual - before
operating this tool.
Caution ! / Attention !
Instruction Manual
WEEE - Waste Electrical and
Electronic Equipment This
machine should be disposed of
as Electrical & Electronic Waste.
Fuse
INTENDED USE
• This power tool is intended to be used for
drilling holes with annular cutters and twist
drills, in an industrial environment.
• The machine is designed to be held onto
a magnetisable surface using its electro-
magnetic base.
• This power tool should be used in a weather
protected environment, and be used with
the accessories provided, or Evolution Power
Tools recommended accessories only.
• The power tool can be used vertically,
horizontally and inverted, provided the
magnetic adhesion and work environment
allow.
WARNING:
To prevent ingress of fluids
into the electrical system, cutting paste
should be used rather than cutting fluid when
using the machine in the inverted position.
PROHIBITED USES
• This power tool should never be used without
a ground or protective earth connection.
• This power tool should not be used in a
potentially explosive environment.
• This power tool should not be use in a wet
or humid environment where water could
be drawn into the power tools cooling and
ventilation system.
• If the power tool is used in the inverted or
horizontal position, cutting fluids should not
be used to prevent ingress of fluids into the
electrical system. Cutting paste should be
used instead.
• This power tool should never be positioned
on a work piece between the electrode and
ground of an arc type welder. Damage to the
machine will result as the welder will ground
through the power tools ground or earth cable.
• This power tool should not be used where
the voltage is abnormally lower than the
rated voltage, subject to voltage tolerances.
Check the power tool rating plate, check the
voltage available.
