16
www.evolutionsteel.com
SETTING UP
WARNING:
Before using the machine ensure that you have
read the sections on the intended and prohibited of use of
this machine.
This machine should only be used for hole boring/drilling whilst
attached to the work piece by the electro-magnetic base.
WARNING:
This machine is intended for use at any angle,
but only if the electro-magnet is in full working order and has
sufficient hold on the work piece material.
The safety strap or chain should be attached in case of power
failure or machine malfunction.
The safety strap or chain should NOT be used as an alternative to
the magnet for clamping purposes.
Always ensure the strap or chain is correctly fitted and the machine is
secure BEFORE starting the machine.
COOLANT / LUBRICANT FLOW.
Note:
It is recommended that a Soluble Oil is used as other
coolants/lubricants may have a high viscosity and may not flow
easily to the cutter.
Ensure that the Coolant/Lubrication bottle is filled with suitable
Coolant/Lubrication liquid and that the ON/OFF tap is in the ON
position.
• Ensure that the work piece is flat, clean and free from any rust,
coatings or other contamination.
• Position the machine onto the work piece.
• Connect the 13A plug into a 13A (120V/16A plug if US) mains supply
socket and switch on at the socket.
• Energise the magnetic base by selecting the ON position of the
RED switch located at the rear of the machine
(refer to Fig.4).
The machine should now be firmly attached to the mild steel plate.
Before commencing the cutting operation check that there is
sufficient Coolant/Lubrication flow at the cutter.
