TSMIP-10GE Series
IP Transport Stream Monitor
Revision 1.0
Page-7
3.
INSTALLATION OF TSMIP-10GE
Upon unpacking, the user should find:
1 x TSMIP-10GE
2 x Power cords contained in a plastic bag
2 x Mounting brackets contained in a plastic bag
Remove the power cords from their package and connect each one to one of the two black power cords
on the rear plate of the TSMIP. Then connect the other end of each power cord to a power source that
meets product requirements. Connecting to a power source should automatically power the device on.
If there was a problem, pressing the Power button manually should power on the unit.
3.1.
CONFIGURE IP INTERFACES TO THE TSMIP
a. Connect RS 232 cable to the TSM and set 115200 bitrate. Login and password is “customer”.
Figure 3-1 : Configure IP Interfaces to the TSMIP
b. Type 1 to open Network Configuration menu.
c. Type 1 to open Control port menu.
d. Type 2 to set IP address.
e. Type 4 to set Gateway.
f. Type x to exit Control port menu.
