HD9690 Series HDTV Graticule Generator Manual
Page 5-6
Revision 1.5
TECHNICAL DESCRIPTION
5.3.1.2.
Step 2 – Establishing a Valid Network Connection
9. Connect a crossover network cable from the PC/laptop to the unit
10. Open a DOS window. This can be accomplished by using the run command under the start button,
type “cmd”; see figure below for an example:
11. “Ping” the IP address of the module being upgraded to confirm that you have a valid network
connection. In the command prompt window type:
ping xxx.xxx.xxx.xxx
<Enter>
(IP address of
the module)
If a proper network connection has been established, a “reply” is displayed on the DOS window. If
there is a faulty network connection, a “Destination Host Unreachable” message is provided. If this
occurs, either the IP addresses of the nodes should be verified or the network (Ethernet) cable is
faulty. For more information, please see the INSTALLATION & CONFIGURATION chapter of this
manual.
5.3.1.3.
Step 3 – Upgrading the Application Code
12. Obtain the new application code and place it on the local drive of the PC
13. In the command prompt window type:
ftp xxx.xxx.xxx.xxx
(IP address of the module)
14. Press the <Enter> key when prompted for a “Username”.
