evertz HD9690 Series, Instruction Manual

Page: 55 / 130

HD9690 Series HDTV Graticule Generator Manual
FRONT PANEL OPERATION
Revision 1.5
Page 3-17
3.5.2.3. Controlling the Opacity (Transparency) of the Mask
Opacity: 100% 75% 50% 25%
This item is used to control the opacity (transparency) of the
mask object
Select
100% to have a solid (100% opaque) mask. The mask will completely cover the picture in the
colour set by the Colour control.
Select
75% to have a 75% opaque (25% transparent) mask . The mask will be keyed with a mix ratio of
75% mask and 25% picture.
Select
50% to have a 50% opaque (50% transparent) mask . The mask will be keyed with a mix ratio of
50% mask and 50% picture.
Select
25% to have a 25% opaque (75% transparent) mask . The mask will be keyed with a mix ratio of
25% mask and 75% picture.
3.5.3. Controlling the Mask Attributes
When the mask object is selected the CTRL SEL button is used to select which of its attributes (colour,
position, size, or individual edges of the object) will be adjusted by turning the shaft encoder knobs. Press
the
CTRL SEL button until the desired CTRL SEL item is shown on the front panel. When you have
chosen the desired CTRL SEL item press the MASK button again or turn one of the shaft encoder knobs
to begin controlling the selected attribute of the mask . The selected attribute for control will show on the
ctrl line of the OSD.
The items that are shown in the
mask CTRL SEL menu depend on the MODE settings and the settings in
the SETUP menu. In the sections describing the CTRL SEL items, the relevant settings from the mask
MODE and SETUP menus are shown where necessary.
3.5.3.1. Controlling the Mask Colour
Colour The colour of the mask object can be adjusted in the range of “0” through “14”, in single digit
increments, using either shaft encoder. The colours that will be displayed for each value are
shown in Table 3-2.
3.5.3.2. Controlling the Mask Size (Mask Centred, Aspect Ratio Off)
Setup menu Force centre
no
or
Setup menu Force centre
yes
Mode menu Aspect ratio
off
Mode menu Aspect ratio
off
Mode menu Centre H + V
Size When the mask is centred and aspect ratio MODE is Off, the left shaft encoder is used to
adjust the height and the right shaft encoder is used to adjust the width of the mask about the
centre of the raster.