EverSewn Sparrow QE, Instruction Manual, Page: 46 / 48

44
SETTING OF LCD, LED LIGHT, and BEEP
You can adjust the brightness of the LCD screen when it is hard to see. Also, you can switch LED light on and off.
By setting off of the beep, you can operate the machine without beep.
1. Turn off the power switch. (Symbol O )
2. Push the bobbin winder spindle to the right.
3. While touching the needle up-down/slow button,
turn on the power switch. (Symbol
I
)
The setting screen for LCD, LED light and beep is
displayed.
4. Set each function as below.
a: LED light
Every time touching the function button (a), LED
light switches on or off.
ON : LED light turns on.
OFF: LED light turns off.
b: Beep
Every time touching the function button (b), beep
switches on or off.
ON : Beep sounds.
OFF: Beep does'nt sound.
CAUTION: To prevent accidents.
Pattern Tension
Width/
Length
Tack/
Cut
Brighter
Function
button
Darker
c, d: LCD
Every time touching the function button (c) or (d), ▼ of the scale will move and the brightness changes.
: Touch the function button (c), if you want to make the brightness of the screen brighter.
: Touch the function button (d), if you want to make the brightness of the screen darker.
5. When you finish setting, press the function button on the left end ( ).
After the setting screen of "winding the bobbin" will appear, push the bobbin winder spindle to left and continue
operating.
If you want to keep setting, you have to touch the function button on the left end (
) before turning off the
power switch.
- If you turn off beep, the warning sound will not sound when you operate the machine incorrectly. Pay attention
to operation.
- When call this function, do not press the button other than the needle up-down/slow button. It may cause
malfunction.
d
c
b
a