EverSewn Sparrow QE, Instruction Manual, Page: 22 / 48

20
NOTE:
The needle threader is used for needle sizes 11/80 -
16/100 and thread sizes 50- 100.
CAUTION: To prevent accidents.
1. Pull thread from needle bar thread guide and
continue gently pulling thread downwards until
you reach the front of the extension table.
Lower the presser foot.
NOTE:
Check that the needle is raised.
If it is not so, raise needle by turning the hand
wheel toward you.
The mark ( ) of hand wheel comes to the top.
Pattern Tension
Width/
Length
Tack/
Cut
Pattern Tension
Width/
Length
Tack/
Cut
D. THREADING THE NEEDLE EYE
CAUTION: To prevent accidents.
2. Lower the needle threader lever.
The lever will stop at lower position.
The threader will turn and the hook pin will go
through the needle eye.
3. Draw thread through needle threader ( ) and
pull toward the right.
4. Draw thread into the guide( ).
Thread will be hooked to the ( ).
5. Hook the thread to the thread cutter ( ) from
back to front. Pull and cut thread.
6. Lower the lever once more and release the lever.
Hook will turn and pass thread through needle
eye while making a loop.
7. Pull thread out from needle eye.
8. Raise the presser foot and pull upper thread
about 10 cm toward the back of presser foot.
- Do not put your fingers under the needle.
-Do not rotate the hand wheel when threader lever
is lowered.
Turn off the power before carrying out the below
operation.