EverSewn Sparrow QE, Instruction Manual, Page: 19 / 48

17
Pattern Tension
Width/
Length
Tack/
Cut
C. INSERTING THE BOBBIN
1. Place bobbin into bobbin holder ( ) with the
thread unwinding counter clockwise.
2. Draw thread into notch ( ) with holding the
bobbin.
3. Pull thread along the groove from up to down.
Pull thread to the right to cut the thread ( ).
4. Replace the bobbin cover. Set the left tabs ( )
into the holes in needle plate and push the right
side of bobbin cover down until it clicks into
place.
7. Hold the thread by your left hand and wind the
thread to the bobbin 4-5 times clockwise.
8. Hook the thread under the front wing of the
bobbin winder thread guide ( ) from left to right
and cut the thread.
9. Start the machine by pressing the start/stop
button or pressing the foot controller pedal.
The bobbin winding will stop automatically when
bobbin is full. (Release the pedal.)
10. Push the bobbin and spindle to the left.
Remove the bobbin from the spindle. Hook
thread to the thread cutter ( ) from left-back to
right-front.
NOTE:
This machine can start to sew without drawing
up the bobbin thread.
If you want to draw up the bobbin thread, see
page 26.
CAUTION: To prevent accidents.
Turn off the power before carrying out the below
operation.