59
RS485
PTZ Protocol:
Select PTZ protocol
,
choose from the following protocols: Transparent, Pelco D, Pelco P, Everfocus, or
Samsung. (
NOTE: all cameras on the bus must use the same protocol
)
485 ID:
This is the ID used by the EKB500 to send commands to the DVR. On an RS485 connection, every device (PTZ,
DVR and controller) must be assigned a unique ID number between 0 and 127.
Baud Rate:
The speed used to transmit instructions or information through the RS485 port on the DVR. Choose from the
following speeds: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 BPS.
Data Bit:
The number of data bits used in a data packet or word. This can be set to 8 or 7.
Stop Bit:
This field is to set the number of stop bits indicating the end of a data packet. This can be set to 1 or 2.
Parity:
This selects the transmission error checking rule. Choose either None, Odd, or Even.
Control
One remote control can be used to operate several DVRs. The DVR to be addressed is selected by pressing the key
corresponding to its ID number on the remote control.
IR Remote ID:
ID used by the remote control to select this DVR. This can be set from 1 to 4.
5.9.5
Misc.
Firmware
Current Firmware Version:
Displays the current version.
Firmware Upgrade:
Press “Upgrade” to upgrade the firmware.
NOTE:
To perform a Firmware Upgrade, you will need
to connect a USB flash device that has the desired
firmware.
Do not disconnect the USB device or turn
off the power to the unit during the upgrade;
this
can cause the system to fail to recover, requiring
factory service to repair.
Configurations
Load Factory Default:
Click “Load” to restore all menu settings to the default values. User Account, Network IP
Settings, and Time are not affected.
3GP streaming is disabled by default.
Load From USB:
Click “Load” to upload saved DVR configuration settings from a USB flash device.
Save To USB:
Click “’Save” to save the current DVR configuration settings to a USB flash device.
Language:
Choose which language the DVR uses. The available languages may vary based on region.
5.9.6
Quick Archive
Select the time interval that the DVR should wait before
archiving recorded material to the archive space.
