EVCO S.p.A.
EVDRIVE04 | User manual ver. 1.0 | Code 144EPD4I104
Page 33 of 78
The first pages are dedicated to the end user and permit display of major features of the EVDRIVE04, any alarm
messages, or whether it is necessary to resynchronise or reset the machine after changing parameters. In the
PageUser2 , the fourth line is visible and blinking only if there is a request for resynchronization; the last line
signalizes a request to disable (blinking "disable request”) or a request to reset the board (negative blinking “reset
request”).
In the “User configuration” pages, some manual and debug mode functions are also available, including the direct
setting of SH set-point to pass to the algorithm.
In the “Alarm Status” page all the warnings and alarms are displayed.
7.2.2
Installer menu
Enter the Installer menu pressing
in Page User 1 or pressing
in Page User.6
The default level 1 password is “10”.
Page Installer.1
Page Installer.1.a
Page Installer.1.b
Page Installer.1.c
These menus permit modification of most driver parameters.
In the “Main param. settings” the user can change the control type (analog positioner or SH algorithm), the algorithm
sample time, the algorithm parameters set to be used and the parameters for each set, valve
start-up position, valve position in case of probe or communication error, valve stand-by position, etc.
The “Alarm param. settings” permit to enable or disable each alarm and settings the parameters.
7.2.3
Manufacturer menu
Enter the Manufacturer menu selecting “Manufacturer Menu” using
or
and
to enter;
The default level 2 password is “20”.
Page Manufacturer 0
