2.
Remove the bolt using the Torx T30 bit.
3.
Turn the station over and remove the charging cable from the station.
4.
If the rubber seal is not on the charging cable plug, remove the rubber seal from the station
socket.
5.
On the new charging cable, make sure that the rubber seal is in place and not twisted. The rubber
seal must fit correctly to ensure that the enclosure rating is met.
6.
Push the charging cable firmly into the station.
7.
Turn over the charging station and place it on a soft surface.
8.
Install the Torx M6 x 45 bolt using a Torx T30 bit.
9.
Install the station.
EN
6. Maintenance instructions
30