6.
Remove the installation kit bag, the rubber seal and strain relief bag, and the connector cap.
7.
Open the package marked with the cable. To prevent damage, leave the cable in the package until
you are ready to install it.
4.3. Install the wall dock
See the corresponding illustrations in manual B.
1.
Prepare the installation area as follows:.
a. Hold the drilling template on the wall and level it using a spirit level.
b. Mark four screw points on the wall then remove the drilling template.
c. Drill four 8 mm holes to a depth of 70 mm.
d. Install four 8 mm diameter wall plugs.
e. Partially install four Torx 5 x 70 mm screws using the Torx T25 bit, allowing sufficient length for
the wall dock to be installed.
2.
Install the wall dock as follows:
a. Place the wall dock onto the four Torx 5 x 70 mm screws then slide it downwards to engage
the screws.
b. Tighten the four Torx 5 x 70 mm screws using the Torx T25 bit.
3.
If installed, remove the connector cap.
4.
Remove three Torx T20 screws and one slotted screw, then remove the transparent cover.
5.
Prepare the rubber seal for cable feed-through as follows:
a. Measure the diameters of the power supply cable and the optional Smart Charging and EV
Ready certified connection cables.
b. Cut out the corresponding feed-through diameters from the rubber seal.
c. Feed the cables through the rubber seal.
6.
Cut the power supply cable and the optional Smart Charging and EV Ready certified connection
cables so they extend a minimum of 180 mm above the rubber seal when they are installed in the
station.
7.
Secure the cables in the wall dock as follows:
a. Choose the side of the strain relief that will be the best fit on the cables.
Note:
The strain relief is reversible.
b. Install one part of the strain relief in the wall dock.
c. Slide the rubber seal carefully into the wall dock.
Make sure that the cables are correctly seated in the strain relief.
d. Install the second part of the strain relief and the two Torx M4 x 40 screws using the Torx T20
bit.
8.
Prepare and connect the power supply cable as follows:
4. Installation instructions
EN
19