Eusso 2 & 4 Port VoIP Gateway, User Manual

Page: 67 / 112

ITG User’s Guide
Chapter 8 Command Line Interface
The ITG has a built-in command line interpreter and provides users a Command Line
Interface (CLI). You can configure ITG by entering commands from the CLI.
You can access the CLI from a VT-100 terminal or terminal emulator connected to the RS-
232 port on the front panel or through a Telnet session.
8.1 Connection through Serial Port
The serial port of the ITG is fixed at the following settings:
Baud rate 19,200
Number of data bit 8
Parity check None
Number of stop bit 1
Flow control None
To access the ITG through the RS-232 serial port, follow the steps below:
1. Insert one end of the serial cable that came with the ITG into the 9-pin RS-232 port
(labeled User Console) on the front panel.
2.
Insert the other end of the cable into your terminal’s serial port.
3.
Configure the terminal so that settings for baud rate, number of data bit, parity check,
number of stop bit and flow control capability exactly match ITG’s serial interface.
(Refer to you terminal documentation for more information about setting up these
features).
4. Press <Return> from the terminal.
5. The ITG displays the following prompts on the terminal and you are ready to access the
CLI then.
EITG>
8.2 Connection through Telnet
To use Telnet, you must have previously set the IP address using the net set ip command for
the ITG. Refer to the section describing the net set command later in this chapter for
information about setting the IP address. Up to two sessions through Telnet are possible. To
access the ITG from a remote host with Telnet, perform the following tasks:
Command Line Interface
55