Eurotherm TC3001, User Manual

Page: 45 / 79

Transit Inspector Pro 46
Administrating Module
User Guide
2. Open Computer object properties (see SecurOS Administration Guide ) and setup the following
parameter:
• Disks to store archive → set
Read/Write
access for video for at least one hard disk (e. g.
for
C
).
3. Create the required number of the Video Capture Device object (see SecurOS Administration
Guide ) due to the type and number of cameras controlled from the very server.
4. Create Camera object with the following parameters:
• Channel number → set the actual number of the labeled BNC connector the first camera
is attached to.
• Resolution → it is recommended to set the
High (CIF2)
value.
•
Pre-recording phase duration
→
set approximate train passing time (s) by camera view.
5. Create Database object (see 4.2.2 Database on page 24 ). Define database for recognized number
records and retention period optionally. Make sure that the server
PostgreSQL
DBMS was set
for work with the external IP addresses.
6. Choose the Computer object that corresponds to the number recognition server.
Note:
Procedure of the number recognition server configuration is similar for all recognition servers.
7. Create the Transit: number recognizer object (see 4.2.3 Transit: number recognizer on page 25 )
with the following parameters:
• Analyse video from camera → define the corresponding Camera object.
• Synchronously record video from cameras → define additional cameras to record video.
•
Video recording mode
→
select the proper recording mode.
•
Recognize numbers of wagons incoming from
→ select the proper checkboxes due to
the task.
•
Redirect results to
→ define the Database object or enable the
Consolidator
field if the
current recognizer is not a main one.
•
Number detection and speed estimation
→ type in manually or set by the utility
(see 4.2.3.2.1 Visually Setup Recognizer Parameters Utility on page 33 ) the parameters
of number detection area.
8. Create the Transit: assisting recognizer object (see 4.2.4 Transit: assisting recognizer on
page 36 ) with the following parameters:
•
Analyse video from camera
→
define the corresponding Camera object.
•
Synchronously record video from cameras
→ define additional cameras to record video.
• Video recording mode → select the proper recording mode.
•
Recognize numbers of wagons incoming from
→
select the proper checkboxes due to
the task.
•
Redirect results to
→
define the Database object or enable the Consolidator field if the
current recognizer is not a main one.
www.isscctv.com