Eurotherm 590A SERIES, Product Manual

Page: 4 / 109

4. The motor may be energised unless the installation specifically prevents unexpected or unsequenced energisation of
the motor.
5. Due to the use of electricity in this product, only competent persons may install or service this product and avoiding
the danger of death by electrocution or burning by using established safe working practices.
In these situations the users own risk assessment should provide for example lockable isolators to provide safe working
conditions.
NOTE: During power loss the product will not operate as specified.
MAINTENANCE: Maintenance and repair should only be performed by competent persons using only the
recommended spares (or return to factory for repair). Use of incorrect parts may create a hazard and risk of injury.
WHEN REPLACING A PRODUCT IT IS ESSENTIAL THAT ALL USER DEFINED PARAMETERS
THAT DEFINE THE PRODUCTS OPERATION ARE CORRECTLY INSTALLED BEFORE RETURNING
TO USE. FAILURE TO DO SO MAY CREATE A HAZARD AND RISK OF INJURY.
PACKAGING: The packaging is combustible and if disposed of in this manner incorrectly may lead to the generation
of toxic fumes which are lethal.
WEIGHT: Consideration should be given to the weight of the product when handling.
REPAIRS: Repair reports can only be given if sufficient and accurate defect reporting is made by the user.
Remember, the product without the required precautions can represent an electrical hazard and risk of injury, and that
rotating machinery is a mechanical hazard and risk of injury.
PROTECTIVE INSULATION:
1. All exposed metal insulation is protected by basic insulation and bonding to earth i.e. Class 1.
NOTE: Earth bonding is the responsibility of the installer.
2. All signal terminals (terminals 1-39) are SELV, i.e., protected by double insulation (Class 2). The purpose of this
protection is to allow safe connection to other low voltage equipment and is not designed to allow these terminals to be
connected to any unisolated potential.
Ensure all wiring rated for highest system voltage.
NOTE: Thermal sensors contained within the motor are to be double insulated.
ENCLOSURE:
To maintain compliance with the European Low Voltage Directive Standards VDE 0160
(1994)/EN50178(1998) the unit should be mounted inside a suitable control cubicle requiring a tool for
opening.
RCDS:
Compatible with Type B RCDs only.
CONTROLLER WARRANTY: For further details on Eurotherm Drives Controller Warranty and Repair refer to the
Standard Conditions of Sale IA058393C.
EUROTHERM DRIVES RESERVE THE RIGHT TO CHANGE OR ALTER THE SPECIFICATION OF THIS
PRODUCT WITHOUT NOTICE
This manual was downloaded on www.sdsdrives.com
+44 (0)117 938 1800 - info@sdsdrives.com