Eurotherm Drives 620 Com, Product Manual, Page: 143 / 203

8093#
)XQFWLRQ # %ORFNV
953# 9HFWRU # 'ULYH #0# +$ 7968;7
3 4# 02'(
Selects the operating mode of the P3 Serial port,
Enumerated Value Type
0 DISABLED
1 EI ASCII
2 FIELD BUS
3 4# %$8' # 5$7(
Sets baud rate for P3 serial port.
300, 600, 1200, 2400, 4800, 9600, and 19200. Baud rates higher than 9600 may become unreliable with a PC.
(5525 # 5(3257
See EE ERROR CODES.
NOTE: Writing to this parameter has the effect of resetting it. The value is also reset by the P1 port.
3$66:25'
00, # (175,(6
....PASSWORD
......ENTER PASSWORD [200] = 0x0000
......CHANGE PASSWORD [201] = 0x0000
The 620 Vector Drives have a password system which can be used to prevent unauthorised access to the set-up
parameters. Once the user has set a password then the set-up parameters become read-only. Order to change the
parameter values the correct password must first be entered.
All drives shipped from the factory have a default password value of 0000.
The
PASSWORD
sub menu has 3 entries as follows:
ENTER PASSWORD This option is used to enter the password to regain access the set-up parameters.
Password value entered must match the value previously set up in the CHANGE
PASSWORD menu to gain access to the set-up parameters.
CHANGE PASSWORD This option is used to change the password or to initially a user password. A
password has been set up, the PARAMETER SAVE menu be used to save the
password in non-volatile.
CLEAR PASSWORD This option is used to clear the password value displayed under the ENTER
PASSWORD menu. This menu is accessed the ENTER PASSWORD value is to
"0000". The CHANGE PASSWORD value is-zero then the set-up parameters
will be locked.
(;$03/( #4=# 352*5$00,1* # 2) # 3$66:25'
1) Access the CHANGE PASSWORD menu. display will show:
CHANGE PASSWORD
0x0000
2) Using the up and down arrow keys, set the password value required as a 4 digit hexadecimal number. display
will show, for example:
CHANGE PASSWORD
0x1234
3) When you are happy with the password make a note of the value and keep it in a safe place.
4) Press the 'E' key to take you out of the CHANGE PASSWORD menu. Display will show:
5) This is to remind you to save the password along with the other parameters before you remove power from the
drive. the 'E' key again to exit the
CHANGE PASSWORD
menu.
This manual was downloaded on www.sdsdrives.com
+44 (0)117 938 1800 - info@sdsdrives.com