Eurosystems La Zappa, Manual

Page: 12 / 28

ENGL
ISH
7

TILLER : HOW TO START
- Insert the plug into the socket 230 volt,
- Make the wire to pass into the wire-holder (13) then into the rod (10) in order to make it away from the rotating tines
(fig. 2)
.
- Press the yellow switch (1) and pull the lever (2) (fig. 5) .
- Once the engine is switched on , let the switch to go (1) making the lever to be still pressed (2) N.B. the electric engine is not showing , at the beginnng
, the same torque of a piston engine , so it is necessary to make the rotavator to be up from the ground making the spur to play ( fig. 1 part 46) .
When you get to the tools max rotation speed it is possibile to start working , making the rotavator to touch the ground.
- As far as concerns the unit switching off and the rotavators stopping, slacken the yellow lever
(fig. 5 part. 2)
.

HOW TO DISASSEMBLY ROTAVATORS
To disassemble the rotavators, please unscrew the nut (52), take the screw (56) away and slip the rotavators out. Clean and slightly grease the shaft
before to go on assemblying a new rotavator or another accessories.

HOW TO MAINTAIN – CHANGE OIL
Generally speaking oil should be changed every 60 hours working (viscosity oil sae 80) . Go on as follows : loosen the screw-cap.
(fig. 1 part. 59)
and put the unit in on an inclined position and make the oil to flow out . Put in the unit some fresh oil for a quantity about 0,25 lt. In order to verify oil
level put the machine in a horizontal position , unscrew the cap (fig. 1 part. 59) and check the oil to be a little bit less than the hole lower level . The
filling/emptying corresponds to the oil level.
ATTENTION! The used oil must not be drained into the sewer system or waterworks. In order to prevent any pollution to the water-table. Most garages
have used oil deposits, or use the authorized deposits according to your local authority regulations.

TECHNICAL FEATURES
Engine : voltage rating 230V, 50 Hz, power 1300 W.
Transmission : from motor pulley to worm screw by belt; worm-screw-helical gear (in oil-bath) for transmission to drive shaft. Cultivator: with hoes,
working width 36cm., complete with safety case Max tiller speed: 120 RPM. Safety device: all cultivators are equipped with a safety device which
disengages the transmission automatically when the corresponding control lever is released.

NOISE AND VIBRATION LEVEL
Measured sound pressure level with En709, Leq = 69,4 dB (A).
Measured sound power level with En709, Lwa = 80,8 dB (A), with a uncertainty value K = ±0,6 dB (A).
Handlebar vibration in compliance with EN 709 and ISO 5349. Level max detected = 1,33 m/s
2
, uncertainty value K = ±0,53 m/s
2
.

ACCESSORIES ON REQUEST
Rotavators cm. 16: it is easy to use it for an easier hoeing on narrow rows - De-thatcher: it is good to eliminate the grass entanglement and musk from
fields and gardens – Aerator: it is a good tool for your own garden care as the blades can make little furrows into the ground and aereate it - Ridging
plough: it is necessary to use it to cut small furrows before sowing.
The rotavators and aerator and ridging plough can be assembled on the rotavators-holder shaft with screw M8 and nut , after having disassembled the