Eurosystems La Zappa, Manual

Page: 13 / 28

ENGL
ISH
8
standard pin (cm. 36). The de-thatcher has to be fixed on the hob spindle of the machine with an elastic plug, after the disassembling of the standard
cutter. The ridging-plough , on the contrary can be assembled to the machine instead of the spur and can be fixed with a “r” pin. It is absolutely forbidden
to use tools/equipment other than the above described ones. Pay attention to the tools rotating direction.

TROUBLESHOOTING
Before servicing the machine, disconnect the power supply (disconnect the plug from the power socket or disconnect the
battery).
Problem Solution
The engine is not working check if the tiller plug is fitting into the power cable socket.
check if the power cable plug is fitting into the power socket.
if the power cable is damaged , please change it.
The rotavator is not turning check if the rotavators are tightened to the tines shaft.
make sure to remove any foreign body , check if any damage occured to the tines.
The rotavator is not efficiently working clean the rotavator and remove any foreign body.
In case you are not able to remedy the defect/damage according to a.m. table, please contact an authorized service center only .