European Home GVF-42, Installation, Operation And Owner'S Manual

Page: 24 / 32

OPERATING the BURNER
G Series Linear Hearth Burner
European
Home
.com 24
MANUAL
KNOB IN
ON POSITION
MAIN VALVE KNOB
Gas Control Valve
Setting the Temperature.
Select either the

Temp
mode or the

Temp
mode by briefly pressing the
SET
button.
Hold the SET button until the TEMP display flashes.
Set the desired temperature with SMALL FLAME or LARGE FLAME .
Press
OFF
to complete the program.
Setting the Timer.
Select Timer mode by briefly pressing the SET button.
Press and hold the SET button until the P1

is displayed, and the time flashes. Set the hour by pressing
LARGE FLAME
and set the minutes by pressing
SMALL FLAME
.
Briefly press SET button for the next burner cycle time.
Automatic Turndown
1. In Manual/Temperature/Timer modes, the valve will turn to pilot flame if there is no change in flame height for a six hour
period. In Temperature or Timer mode, if the ambient room temperature changes, the flame height will adjust automatically to
maintain set temperature and the fire will continue to function normally. The valve will turn to pilot flame if the set temperature
and the ambient room temperature remain the same over a six hour period.
2. The valve turns to pilot flame if the temperature in the receiver is higher than 140°F/60°C. The main burner comes back on
only when the temperature is below 140°F/60°C.
Automatic Shut Off
1. With low battery power in the receiver, the system shuts off the fire completely. This does not happen if the power supply is
interrupted.
2. The system shuts off the fire completely if there is no change in flame height for 5 days.
3. The system shuts off the fire if the main burner does not completely ignite approximately 20 seconds after ignition or after
pushing the Ç button.