29
G Series
Linear Hearth Burner
European
Home
.com
Transmitter batteries low.
Replace transmitter batteries. Quality 9V
alkaline recommended.
Receiver batteries low.
Replace transmitter batteries. Quality 1.5V
AA alkaline recommended.
Check that transmitter and receiver are
synchronized.
Reset system, see the installation manual
or the label on the receiver.
Transmitter distance is limited.
1. Straighten the antenna.
2. Replace the receiver.
FUNCTION
POSSIBLE CAUSE
REMEDY
Yes
2.
Magnet unit is energized
thus producing an obvious
latching sound.
No beep
3 short beeps
1 long beep
8-wire cable is off or
not operating
properly.
Confirm proper operation of the 8-wire
cable.
SW-cable
disconnected.
Confirm proper operation of the SW-
cable.
Motor not operating
properly.
Replace gas valve.
Micro switch not
operating properly.
Replace gas valve.
No
No
No
No
3.
Spark will occur
each second.
Ignition components not
operating properly.
Check connection between ignition cable and igni-
tion electrode.
Check ignition electrode spark gap.
Check ignition electrode.
Check ignition cable for damage.
Increase distance between ignition cable and all
metal parts.
Impulse magnet not
operating properly.
Replace gas valve.
Receiver batteries low. Replace transmitter batteries. Quality
1.5V AA alkaline recommended.
No
Ignition sequence stops,
no pilot flame.
No reaction to transmitter
command.
Reset system.
Remove ground bolt and clean ground lug. See Fig. C.1
Do not coil the ignition cable.
Shorten the ignition cable, if possible.
No
Ignition sequence stops, no pilot flame.
Transmitter command is possible.
Replace transmitter batteries. Quality 1.5V
AA alkaline recommended.
No
Yes
Yes
(continued)
1.
Press UP and OFF buttons
to start ignition sequence.
Beep will occur each
second.
APPENDIX C
Summary of Contents for GVF-42
Page 31: ...NOTES ...
