14
7. LOADING RADIO CODESO
The control panel DOESN’T ALLOW TO LOAD any remote control if SAFETY DEVICES are DISCONNECTE
.
Make sure inputs no.
2 STOP (DL5
), no.
5 photocell in CLOSING (DL7)
, no.
6 photocell in OPENING (DL8)
and no.
23
SAFETY EDGE IN CLOSING (DL3)
, are connected.
LED OFF
= input
DEACTIVATED
LED ON
= input
ACTIVATED
If no safety device has been wired, proceed to bridge temporarily the terminal according to chapter
3.6.1.
The control panel has been designed to operate with fixed code or rolling-code remote controls.
Choose the remote control you wish to store carefully: once the remote control has been loaded and memorized,
the control panel shall only recognize that kind of radio code
without possibility of reset
.
Before starting proceed to delete all existing radio codes
.
7.1
DELETING EXISTING RADIO CODES
- Press
SET-TX
and keep pressed for 10 seconds (
DL1
blinks).
-
DL1
turns off.
All codes have been deleted.
7.2
LOADING A REMOTE CONTROL AS START COMMAND
- Press
SET-TX
once:
DL1
blinks (1 blink – stop – 1 blink ….)
- Load within 5 sec. the remote control you wish to store.
The control panel has stored the radio code and goes out the programming automatically.
It is possible to load until 32 different radio codes (Start + Pede 2° radio channel).
7.3
LOADING A REMOTE CONTROL AS PEDESTRIAN COMMAND
- Press
SET-TX
twice.
DL1
blinks (2 blinks – stop – 2 blinks ….)
- Load within 5 sec. the remote control you wish to store.
The control panel has stored the radio code and goes out the programming automatically
.
7.4
LOADING A REMOTE CONTROL AS 2° RADIO CHANNEL COMMAND
(MRX01 jack)
- Press
SET-TX
three times.
DL1
blinks (3 blinks – stop – 3 blinks ….)
- Load within 5 sec. the remote control you wish to store.
The control panel has stored the radio code and goes out the programming automatically.
