Upgrading The Computer
6 - 10 System Memory Upgrade
6
9.
Insert the new module. The module will only fit one way as defined by the
pin alignment.
10. Make sure the module is seated as far into the slot as it will go (DO NOT
FORCE IT). The latches will click into place on the sides of the module.
Make sure they are secure.
11. Reverse the procedures to put the computer back together, and do not
forget all the screws. When you restart the computer the new memory
configuration should be registered.
12. If the system doesn’t properly detect the new memory,
and you are sure
they are properly “seated”
, you may need to run the
Setup
utility.
Figure 6 - 8
RAM Module
Insertion
Summary of Contents for LP-297PB
