Advanced Controls
3 - 8 Switching/Enabling Displays
3
Switching/Enabling Displays
With the
video driver installed
(see
“What to Install” on page 4 - 2
), you can
use its built-in controls to switch between the displays as follows:
1.
Plug the VGA monitor or TV into the appropriate port at the rear of the com-
puter.
2.
Go to the
Intel(R) 82865G
Graphics Controller Properties
control panel
(see
“Intel Video Driver Controls” on page 3 - 5
) and select
Devices
(tab).
3.
Choose the display option from the list on the left.
4.
If you are using and click
Apply
>
OK
to confirm the settings change (you
may need to give the monitor/TV a few seconds to display the picture).
Vertical Refresh Rate
The vertical refresh rate
of your CRT is impor-
tant. If it is too low and/
or you’re using fluores-
cent lighting, the screen
will appear to flicker. To
reduce flickering on a
CRT, use faster refresh
rates (we recommend a
refresh rate of 72Hz or
more). But first check
your monitor’s docu-
mentation to make sure
it can support the rates
listed by the video driv-
er. The default refresh
rate for VGA monitors
(without drivers) is
60Hz.
Figure 3 - 4
Switching Displays
Summary of Contents for LP-297PB
