9
EN
6.
INSTRUCTIONS FOR USE
6.1
INTRODUCTION
It is necessary to set up the appliance before operating, based on the coffee blend type
(more roasted or less) and the degree of grinding.
• After having plugged the appliance in, pull the tab
(12)
at the bottom of the coffee bean
container
(3)
to close it
(Fig. 4)
.
• Remove the cover
(1)
from the container
(8)
and fill it with coffee beans.
• Turn the switch
(9)
to the ON position (the LED on the button lights up and the cooling
fan is activated).
• Replace the cover
(1)
and push the tab
(12)
permitting passage of coffee beans.
6.2
FORKS APPLICATION
(V60 or FILTER COFFEE)
Depending on the production requirements, a fork for the V60
(13)
or a fork for the filter
coffee tray
(14)
can be fitted.
The two forks are magnetic and can be freely applied in the magnetic zone (7) (Fig.
6-7).
ATTENTION
To remove the V60 fork (13), lift it upwards to remove it from the magnetic zone and
then slide it out towards the front of the unit.
6.3
V60 OR FILTER COFFEE TRAY APPLICATION
After applying the appropriate fork, insert V60
(Fig. 8)
or the filter coffee tray
(Fig. 9)
.
6.4
GRINDING SETTING (Fig. 5)
Set grinding by means of the adjusting knob
(10)
, by rotating it clockwise to make powder
finer (Espresso coffee) or anticlockwise to increase the size of its grain (Filter coffee) as
shown on the knob. Setting is stepless; it is to be gradually performed, by grinding some
coffee every two notches maximum.
The grinding adjustment can be seen from the grinding indicator
(11)
.
ATTENTION
If the knob is turned by more than 3 notches with the engine stopped, the machine
can get stuck and / or damaged.
After adjusting the grind with the knob
(10)
, deliver 2-3 doses to make effective the new
grinding.
6.5
FUNCTIONING
To start grinding, turn the switch
(9)
downwards to the "START" position (the LED on the
switch turns ON).
To stop grinding, turn the switch
(9)
upwards to the "STOP" position (the LED on the switch
turns OFF).
ATTENTION
If the grinder remains active for more than 45 seconds, the grinder is turned off but
the switch (9) remains in the "START" position (led off).
