EURA E2000-0004 S2B, Safety Instructions And Operation Manual

Page: 41 / 82

8) Parameter group 100: Basic parameter
F124 Jog frequency (Hz) Range: F112 - F111 Default setting: 5.00 Hz
F125 Accel. ramp
– Jog Mode (sec.)
Range:
Default setting: 0.2 - 3.7KW: 5.0 sec.
5.5 - 30KW: 30.0 sec.
F126 Decel. ramp
–Jog Mode (sec.)
0.1
– 3000 sec.
> 37 KW: 60.0 sec.
There are two modes to activate the Jog frequency: Keypad-control, and terminal-control (programmable digital inputs
DI1…DI6(8) – configuration: F316…F323
).
Keypad-control: With the inverter in STOP mode press key, to display HF-0, in this condition the key works as a
Jog frequency start/stop toggle ( F132 must be configured in the proper way 1 +x+x+x).
Terminal control: A proper configured digital input works as Jog frequency start/stop toggle
Remark: In Jog mode the "catch on the fly" function is deactivated
F127/F129 Cut-Off frequency A,B (Hz) Range: 0.00 - 650.0 Default setting: 0.00 Hz
F128/F130 Cut-Off frequency window A,B (Hz)
Range: ±2.5 Hz
Default setting: 0.0 Hz
Cut-Off frequency to avoid resonance problems
– the inverter transits during accel. / decel. ramps through this frequency areas,
but it can not stay stable within this frequency ranges.
Display configuration:
0: Output frequency / parameter value
1: Motor speed (rpm)
2: Motor current
4: Motor voltage
8: DC-voltage
16: PID control feed back Default setting:
F131 Display: Selection of operating 32: Heatsink temperature 0+1+2+4+8=15
parameters to display during „START“
64: Counter (fspeed+motor-
status (Motor running) 128: Speed (linear - calculated motor-
256: PID set-point DC-voltage)
512: Reserved
1024: Reseved
2048: Motor-Power
4096: Motor-Torque
8192: Reserved
To display a specific parameter, just set Parameter F131 to one of the values in the table above, to display more
parameters, the sum of all values must be set in F131
The key is used to cycle through the various selected parameter values
E2000+_Rev.02 -E- SOFT Rev. 5.09
- 36 -
© 2016-06-KPP-EURADRIVES EUROPE GmbH