EURA E2000-0004 S2B, Safety Instructions And Operation Manual

Page: 60 / 82

11) Parameter group 400: Analog I/O configuration
Analogue output configuration AO1, AO2
F423 Signal type configuration output AO1
Selection: 0=0…5V
1=0…10V, 0…20mA *
Default setting: 1
current/voltage signal
2=4…20mA *
F424 Inverter output frequency assigned to
Range: 0.0…F425
Default setting: 0.05 Hz
minimum output signal on AO1
F425 Inverter output frequency assigned to
Range: F424…F111
Default setting: 50.00 Hz
maximum output signal on AO1
F426 Gain factor AO1
Range: 0…120%
Default setting: 100
*) The DIP-SWITCH U/I must be set, to get current signal on AO 1 output
– see chapter
5) Control hardware and IO/
channel configuration
F427 Signal type configuration output AO2
Selection: 0=0…20 mA
Default setting: 0
current signal only
1=4…20mA
F428 Inverter output frequency assigned to
Range: 0.0…F429
Default setting: 0.05 Hz
minimum output signal on AO2
F429 Inverter output frequency assigned to
Range: F428…F111
Default setting: 50.00 Hz
maximum output signal on AO2
F430 Gain factor AO2
Range: 0…120%
Default setting: 100
F431 Assignation of operating
Selection: 0=Motor frequency Default
parameters
1=Motor-current normalized on 2xI-n) setting: 0
to AO1 2=Motor-voltage (normalized on 230/400V)
3=AI1
4=AI2
5=Impulse input
F432 Assignation of
6=Torque
– normalized to m-n
7=Set via MODBUS Default
operating parameters
8=Target frequency setting: 1
to AO2
9=Calculated speed
10=Torque (motoric)
Assignation motor current: The full range corresponds to 0…2x inverter rated current Assignation
motor voltage: The full range corresponds to the inverter rated voltage (230V/400V)
F433 Multiplier for motor voltage meter
Range: 0.01…5* rated value
Default setting: 2.0
F434 Multiplier for motor current meter Default setting: 2.0
F437 Filter factor analogue output Range: 1....100 Default setting: 10
Pulse output DO1 :
Digital output terminal DO1 can be programmed via F303 as pulse signal output
– configuration is made in a
similar way, as for analogue outputs
F449 Max. frequency pulse output DO1
Range: 0.00…50.00 kHz
Default: 10.00 kHz
F450 0-point offset (%) Range: 0.
0…100.0 %
Default: 0.0%
F451 Multiplier
Range: 0.00…10.00
Default: 1.00
Selection:0=Motor frequency
1=Motor-current normalized on 2xI-n)
2=Motor-voltage (normalized 230/400V)
F453 Assignation of
3=AI1
4=AI2
operating parameters 5=Impulse input Default setting: 0
to DO1 6=Torque
– normalized to m-n
7=Set via MODBUS
8=Target frequency
9=Calculated speed
10=Torque (motoric)
E2000+_Rev.02 -E- SOFT Rev. 5.09
- 52 -
© 2016-06-KPP-EURADRIVES EUROPE GmbH