27971-01A
2
Installation - Unpacking and Inspection
Unpacking and Inspection
Your sunbed comes in two cardboard car-
tons, one for the canopy and one for the
bench and ballast tray. Open the cartons
and remove the sunbed parts as follows.
The canopy is wrapped in plastic. Pull
back the plastic and, with a helper, grasp
the canopy and pull it from the carton
bottom, leaving the plastic wrap and the
carton packaging.
Do not attempt to lift
the canopy with the plastic still on as it
may slip. Do not lift the canopy by its
plastic endcaps.
Leave the bench in its
box until instructed to remove it in
Assembly Procedures
.
Note! The cartons are reusable. You may
wish to save them for future use.
After unpacking the unit, check to make
sure you have received the following:
• Canopy unit
• Bench unit
• Ballast drawer
• Front access panel
• Two large endcaps, one with small
lamps
• Shoulder tanner cover
• Two 10” diameter flexible ducts
• Bag containing necessary assembly
hardware, safety goggles, and pillow.
Inspect these items, including the canopy
and bench, to make sure they are free
from any visible damage. Report the
extent of any damage to the transportation
company.
Record the serial number of the unit in the
area provided at the back of this manual.
This information will be required whenev-
er you call customer service.