27971-01A
Care and Maintenance - Lamp and Acrylic Replacement
32
Lamp and Acrylic Replacement
Introduction
To be assured of maximum tanning effec-
tiveness, change lamps after approximate-
ly 400-500 hours of use. Tanning will con-
tinue after this time but at a slower rate.
This unit is equipped with electronic lamp
starters.They last longer than traditional
“glow tube” starters, light the lamps quick-
er, and reduce blackening on the ends of
the lamps. It is no longer necessary to
change lamp starters when changing
lamps. As long as they function normally,
meaning its lamp fires quickly and consis-
tently, there is no need to change starters.
Opening/Replacing Bench Acrylic
The Bench acrylic does not need to be
removed to perform normal maintenance,
such as cleaning and replacing lamps.
Turn the quarter-turn latches on either side
of the acrylic and lift the front edge. Two
gas springs hold it open.
WARNING
Shock hazard.
Disconnect power before removing
any protective covers.
1. FLIP UP
2. PULL OUT
To remove the Bench acrylic, lift the
acrylic so the gas springs are fully extend-
ed. Each gas spring is held to the acrylic
bracket with a locking pin. Unclip the pin
and slide it out to disconnect the spring
from the acrylic (see below). With the
acrylic open lift it from the bench.
Replace the acrylic by setting the hinge
channel along its back edge in its slot at
the rear of the bench and reconnecting
the gas springs.