27971-01A
33
Opening/Replacing Rear Acrylic
The Rear acrylic is secured by four quar-
ter-turn latches. Using the 6mm hex
wrench, turn each latch 90° to unlock it.
Lift the acrylic out of its channel. Replace
it by setting it in its channel and locking
the latches.
Opening/Replacing Canopy Acrylic
The canopy acrylic is secured by four
quarter-turn latches along its front edge.
While supporting the front of the acrylic,
use the 6mm hex wrench to unlock the
latches. The acrylic will swing down and
rest on the bench.
Removing the acrylic requires two peo-
ple, one on either end. With it open, lift
the front as you gently pull forward and
the acrylic hinge will pull out of the chan-
nel along the back edge. Replace it by
reversing the above directions.
Opening Shoulder Tanner Cover
Turn the quarter-turn latch in the center of
the shoulder tanner cover. Pry the top for-
ward while pulling upward to remove the
cover. Replace it by sliding the bottom
down and pressing the top closed. Turn
the latch to lock.
Removing/Replacing Lamps
After opening the acrylic shield, replace
main lamps as follows.
Step 1
Grasp the lamp at one end and
at the middle and turn the lamp
one quarter turn. Gently remove
the lamp from its holders.
Step 2
Reinstall the lamp by inserting
the pins located on the ends of
the lamp into the slots on top of
the lamp holders and turn the
lamp a quarter turn. It should
click in place.
Removing/Replacing Shoulder Lamps
Remove the shoulder tanner cover. Grasp
a lamp at its base, NOT by the lamp glass.
Pull the lamp straight out of its holder.
Install the lamp by lining up the pins on
the base of the lamp with the holes in the
lamp holder and press into place.
Care and Maintenance - Lamp and Acrylic Replacement