27971-01A
are and Maintenance
31
Cleaning After Use
Clean and disinfect your tanning bed’s
bench and canopy after each use. Use a
non-abrasive disinfectant cleaner that
does
not contain ammonia or ammonia deriva-
tives
. Ammonia may damage the acrylic
shield. Spray the acrylic lightly with disin-
fectant and wipe dry with a clean soft cloth.
We recommend Australian Gold® pH
Neutral Disinfectant Cleaner.
Thorough Periodic Cleaning
Introduction
The cooling fans draw air through the bed
and over time will cause a dust buildup on
the lamps and reflectors. This reduces the
tanning effectiveness of the bed. When a
dust buildup is observed, it is necessary to
thoroughly clean the inside of the unit.
Cleaning the Canopy and Bench
Step 1
Remove the acrylic shields and
lamps as described in
Lamp and
Acrylic Replacement
.
Step 2
With a soft cloth, wipe the entire
length of each lamp.
Step 3
Clean both sides of the acrylic
shields with a non-ammonia dis-
infectant cleaner.
Step 4
Wipe the reflectors with a clean
damp cloth.
Step 5
Reinstall the lamps and acrylic
shields.
Step 6
Clean or replace air filters on top
of ballast drawer and in right
pedestal (see
Under the Bench
).
Mechanical Inspection
Your tanning bed has been built for years of
service. To ensure trouble-free operation
throughout its life, inspect the unit’s mechan-
ical integrity every 400-500 hours of use.
• Inspect the unit’s fasteners verifying that
all are firmly in place.
• Inspect lift springs for signs of wear.
Adjust for proper lift if needed. See
Under the Bench.
• Inspect the power cords and connec-
tions.
• Inspect the acrylics. Broken, cracked or
badly scratched acrylics should be
immediately replaced.
• Check damper operation. The damper
limits the canopy’s movement speed.
The damper looks like a gas spring
attached to the left hinge arm. Replace if
canopy raises and lowers too quickly.
WARNING
Shock hazard.
Disconnect power before removing
any protective covers.