27971-01A
38
Troubleshooting
Problem
Solution
Timer display is indicating E 98
I forgot what address, or “id”, I set
my sunbed to
Timer display changes to indicate
a tanning time after the START but-
ton is pressed but lamps do not
come on
My bed is connected to the T-
Max® Manager remote system and
when the delay time has expired
the timer display starts counting
down but the bed lights do not
come on
My bed won’t work with the T-
Max® Manager remote system
Timer display continues to show
0:00 after the START button is
pressed
My salon suffers frequent, short
power outages and clients com-
plain about losing session time
Unit temperature too high.
1. Allow unit time to cool.
2. Check all fan openings and air filters for obstructions.
3. Verify ambient temperature is below 80°F.
4. If problem persists contact servicer.
By holding the STOP button for 3 seconds the timer display
will briefly blink “id” and your address number.
1. Bypass plug is not installed, see
Remote Connections
.
2. A non-SunStar® bypass has been used. See
Remote
Connections
.
3. If remote is being used, other than T-Max® Manager, the
external timer may not be activated.
4. Remote wiring is incorrect, see the instructions provided with
the remote interface kit.
The auto start feature of the remote system is disabled, see the
instructions provided with your remote system.
The sunbed must first be set to a unique address, see
Remote
Connections
.
1. T-Max® Manager remote system has not yet been set.
2. Sunbed address is not set correctly, see
Remote Connections
.
If you have a T-Max® Manager, changing parameter 23 from
“0” to “1” will allow the tanning bed to remember how much
time was left when power goes out and resume its session
after power is restored. Consult your T-Max® Manager manu-
al for information on setting parameters.