IR1759-MK5-AT3130-EDCONT MINIRAY
TE Connectivity - Aerospace, Defence & Marine
/// Application Tooling
Page
13
of
36
Eye protection must be used when using this tool. Safety glasses should be worn when operating this
tool, to provide eye protection against hot debris, dust, etc.
Distance to Face >
300mm/12”
When operating IR1759 MK5
Never look directly at the lamp when it is energised.
Ensure that the optical filter and optical block assembly are in good condition and have been
correctly fitted.
When used exactly as instructed in this manual, the MINIRAY equipment presents no hazard to the
user.
As with all electrical equipment, the IR1759-MK5 MINIRAY Hand Tool and Controllers must be
operated properly. Carefully read and observe all the instructions and warnings in this manual.
Incorrect use of the IR1759-MK5 MINIRAY equipment can cause serious injury. This equipment must
be operated and maintained only by fully trained and qualified personnel.
Failure to follow the manufacturer’s instructions may void the warranty of this equipment.
The IR1759-MK5 MINIRAY equipment must be operated in accordance with safe working practices
and local safety codes and regulations.
Do not use the IR1759-MK5 MINIRAY equipment for any purpose other than its intended function.
Do not use the equipment on or near fuelled aircraft or in a potentially explosive environment.
A fire may arise if the tool is not used with care. Parts of the MINIRAY Hand Tool get hot during use.
Special care must be taken to avoid heating materials other than the pieces being worked on.
The MINIRAY Hand Tool should be used in a well-ventilated area, never use the tool near solids,
liquids or gases that burn easily.
Be sure that the MINIRAY Hand Tool is not placed on or near flammable materials between
uses.
3.4 Eye Protection and Optical Radiation Hazard
3.5 General Safety Instructions -
MINIRAY equipment
