Chapter 2 Installation
2 - 3
Installing your console and monitor
This section includes installation instructions for
MicroVision FX, and
connector and pinout specifications for the monitor. Follow these steps
to install your
MicroVision FX:
1.
Place console on a hard, stable, flat surface with at least six inches
of space behind it for ventilation and cable clearance. Console
should be at least six feet away from dimmers and high-current AC
lines.
Caution: Do not leave the console in a road case tray or on a soft
surface. This will inhibit proper ventilaion.
2.
Verify that your dimmer connector pinout is correct for
MicroVision
FX. Pinouts for several dimmer types are listed on pages 2 - 6 and
2 - 7. If your dimmer type is not listed, contact your dealer or ETC.
Caution: Your dimmer control common must be compatible with
console control common; they must either be the same level, or the
dimmer control common must float. Verify compatibility with your
dealer if you are not sure.
3.
Locate the power switch at the back of the console, and turn it to
the
Off
position.
4.
Insert the female end of the console power cord in the connector
labeled
Power in
on the back panel.
5.
Insert the male end of the console power cord in a grounded 120V
AC outlet. For 220V AC operation, consult ETC.
6.
Insert the female end of the monitor power cord in the monitor
connector, and the male end of the monitor power cord in a
grounded 120V AC outlet.
7.
Insert the video cable in the monitor. Connect the other end of cable
in the appropriate console connector listed below.
Digital RGB color monitors
DB-9 connector
TTL monochrome monitors
DB-9 connector
Composite monochrome monitors
BNC connector
