ETC ColorSource Spot, Installation Manual

Page: 6 / 20

ETC Installation Guide
ColorSource Spot V1.0
Set Up the Fixture
1. Plug the power cord into the powerCON TRUE1 In connector on the
rear of the fixture.
2. Make any power-thru cable connections prior to applying a power
source.
3. Make any DMX connections, and if the fixture is the last in a DMX
line, terminate the fixture. See Connectors on the previous page .
4. Plug the power cord into the power source.
Power Up
Press any button to wake the display. The display shows the DMX
address. See
Set the DMX Address below .
You can press the Mode button to access the Presets/Sequences menu.
See
Play Presets and Sequences on page 11 .
Adjust the Tilt
The fixture can be tilted up and down and rotated (panned) as needed.
1. Loosen, but do not remove the yoke locking knobs.
2. Tilt the fixture to the desired angle.
3. Tighten the yoke locking knobs.
Set the DMX Address
1. Press any button to wake the display. The display shows the DMX
address.
2. Use the Up and Down buttons to select the DMX address for the
fixture.
You can also set the DMX address using RDM or using the Set Light app.
See
RDM Values on page 15 or Configure Fixtures Using the Set Light App
on page 10 .
ColorSource Spot V Page 6 of 20 ETC