ETC Installation Guide
ColorSource Spot V1.0
Change the DMX Control Mode
You can set the DMX control mode for the fixture to one of four available
mode options.
1. Press any button to wake the display. The display shows the DMX
address.
2. Press and hold the Mode button for 3 seconds. The display shows
ctL
(Control).
3. Press the Mode button. The display shows the current DMX control
mode.
4. Press the Up button or Down button to change the DMX control
mode. (The currently saved mode is indicated by a decimal point at
the end of the mode name.)
•
Stn
: Standard mode (intensity, red, green, blue, strobe, and fan).
This is the default mode.
•
dir
: Direct emitter control (intensity, red, green, blue, indigo,
lime, strobe, and fan).
•
1ch
: 1-channel mode controls the intensity of preset 1 (defaults to
3200 K White).
•
rgb
: RGB mode (red, green, and blue).
5. Press the Mode button to confirm your selection. The display shows
ctL
(Control).
6. Navigate to the
rtn
(Return) option to return to the DMX address
display.
The display will automatically return to the DMX address after 10 seconds
of inactivity, and edits to the DMX control mode will not be saved. This
cancels unsaved changes.
DMX Control Channels
DMX Channel
Stn
Standard
dir
Direct
1ch
1 Channel
rgb
RGB
1
Intensity
Intensity
Intensity
Red
2
Red
Red
Green
3
Green
Green
Blue
4
Blue
Blue
5
Strobe*
Indigo
6
Fan*
Lime
7
Strobe*
8
Fan*
* See
for the DMX values that set these parameters.
ColorSource Spot V
Page 7 of 20
ETC
