ETC Installation Guide
ColorSource Spot V1.0
Emergency Lighting Considerations
Luminaires that are used in emergency lighting applications must provide
a minimum illumination level over the identified means of egress path in
accordance with the Life Safety Code
®
, NFPA 101. A luminaire that is
intended to serve this purpose must be mounted at a height where it will
not readily be subjected to tampering by unauthorized personnel and
where the minimum required illumination level over the egress path can
be achieved. The ETC DMX Emergency Bypass Controller that is driving
the luminaire upon loss of utility power must be programmed to drive the
ColorSource Spot V to full illumination.
Installation
Install a Shutter Barrel
Insert and rotate
one eighth turn
The ColorSource Spot V can be
purchased with or without a
shutter barrel. To install a
shutter barrel you will need a #2
Phillips screwdriver (not
provided).
The ColorSource light engine
includes a barrel screw. The
small screw used to secure the
top of the shutter barrel is
included with the shutter barrel.
1. Align the barrel to the front of the ColorSource Spot V and rotate it
one eighth turn (45°) counter-clockwise before inserting.
2. Insert the shutter barrel into the front of the light engine and rotate
clockwise until it is fully threaded onto the light engine.
3. Insert the barrel screw at the bottom of the light engine and tighten.
4. Insert the small screw into the top of the light engine and tighten
using the Phillips screwdriver.
ColorSource Spot V
Page 4 of 20
ETC
