ETC Installation Guide
ColorSource PAR v1.7
Set the DMX Address
1. Press any button to wake the display. The display shows the DMX
address.
2. Use the Up and Down buttons to select the DMX address for the
fixture.
You can also use RDM for DMX addressing. See
.
Change the DMX Control Mode
You can set the DMX control mode for the fixture to one of four available
mode options.
1. Press any button to wake the display. The display shows the DMX
address.
2. Press and hold the Mode button for 3 seconds. The display shows the
current DMX control mode.
3. Press the Up button or Down button to change the DMX control
mode:
•
5ch
: 5-channel mode (intensity, red, green, blue, and strobe). This
is the default mode.
•
dir
: Direct emitter control (intensity, red, green, blue, indigo,
lime, and strobe).
•
1ch
: 1-channel mode controls the intensity of preset 1 (defaults
to 3200 K White).
•
rgb
: RGB mode (red, green, and blue).
4. Press the Mode button to confirm your selection.
The display will automatically return to the DMX address after 10 seconds of
inactivity, and edits to the DMX control mode will not be saved. This cancels
unsaved changes.
ColorSource PAR
Page 7 of 12
ETC
