ETC Installation Guide
ColorSource PAR v1.7
Restore Factory Defaults
Press and hold the Mode button, Up button, and Down button
simultaneously for 5 seconds. The DMX start address will blink once to
confirm that defaults have been restored.
Error Codes
There are three error codes that may be shown on the user interface.
•
CAL
: Screen toggles between
CAL
and
Err
to indicate a problem with
the color calibration. The fixture will need to be returned to the ETC
factory; contact your local dealer to set up a repair.
•
OtP
: Screen toggles between
OtP
and
Err
to indicate that the fixture
has gone into over-temperature protection mode to avoid damaging
the fixture. Once the fixture has self-cooled, the error will automatically
clear.
•
No App
: Screen toggles between
no
and
APP
to indicate that the
upgraded fixtures have a software issue. Reload software to clear the
error. If the error persists, contact ETC.
RDM Values
Parameter
Fixture
Value
Description
Manufacturer ID
All
0x6574
Electronic Theatre
Controls
Model ID
ColorSource PAR
0x0201
ColorSource PAR
Deep Blue
0x0202
DMX Start Address All
0x00F0
Range = 1–512
DMX Personality
All
0x00E0
1 = 5 Channel
2 = Direct
3 = 1 Channel
4 = RGB
Output Frequency
All
0x8123
0 = Standard (1.2 kHz)
1 = High (25 kHz)
ColorSource PAR
Page 12 of 12
ETC
