ETC Installation Guide
ColorSource PAR v1.7
Set Up the Fixture
1. Plug the power cord into the powerCON In connector on the rear of
the fixture.
2. Make any power-thru cable connections prior to applying a power
source.
3. Make any DMX connections, and if the fixture is the last in a DMX line,
terminate the fixture. See
Connectors on the previous page
4. Plug the power cord into the power source.
Power thru
Power in
Data in
Data thru
Mode
Up and Down
User interface
Power Up
Press any button to wake the display. The display shows the DMX address.
See
Set the DMX Address on the facing page
You can press the Mode button to access the Presets/Sequences menu. See
Play Presets and Sequences on page 8
.
Adjust the Tilt
The fixture can be tilted up and down and rotated (panned) as needed.
1. Loosen, but do not remove the yoke locking knob.
2. Tilt the fixture to the desired angle.
3. Tighten the yoke locking knob.
ColorSource PAR
Page 6 of 12
ETC
